2005 KAWASAKI PRAIRIE 360 OWNERS MANUAL PDF

Offroad Vehicle Kawasaki PRAIRIE Service Manual. All terrain vehicle Offroad Vehicle Kawasaki Brute Force 4x4i EPS Owner’s Manual. ( pages). Title: Kawasaki Prairie KVF Service Repair Manual DOWNLOAD, Author: Diana Kunkle, Length: 2 pages, Published: KVF All Terrain Vehicle. Service Manual. All rights reserved. No parts of this publication may be reproduced, Read OWNER’S MANUAL before operating.

Author: Mekora Zulkizilkree
Country: Lithuania
Language: English (Spanish)
Genre: Life
Published (Last): 16 May 2007
Pages: 421
PDF File Size: 20.34 Mb
ePub File Size: 13.23 Mb
ISBN: 733-2-28017-776-7
Downloads: 89588
Price: Free* [*Free Regsitration Required]
Uploader: JoJorn

This will burn out the diodes in the electrical parts.

The drive pattern can be a little closer to the toe and the coast pattern can be a somewhat longer and closer to the toe. NOTICE Do not disconnect the praiie leads or any other electrical connections when the ignition switch is on, or while the engine is running.

Calaméo – Kawasaki Prairie KVF Service Repair Manual DOWNLOAD

Ring Gear Shim s 4. Comments to this Manuals Your Name. Don’t show me this message again. If the seal is torn or is leaking, replace the bearing.

2005 Kawasaki Prairie 360 — Owner’s Manual

Never reuse old brake fluid. Tire Air Pressure when cold Front: Torque – Ignition Coil Mounting Bolt: Apply molybdenum disulfide grease. Carburetor Drain Tube 3. Right Headlight Lead 2. Now the front wheels are parallel to each other and to the center line of the vehicle.

  LIBRO LA META DE ELIYAHU GOLDRATT PDF

If the steering action is not smooth, or if the steering binds or catches before the stop, lubricate the steering stem bearing. Drive Bevel Gear Owneds 3. More frequent inspection is necessary if the vehicle is subjected to hard usage.

Ball Bearing and Needle Bearing Do not remove pressed ball or needle unless removal is absolutely necessary. Oil Seal Driver, Brake Cable Rear 4. Overall Height 1 mm Do not use fluid from a container that has been left unsealed or that has been open for a long time.

Then tighten them according to the specified se- quence to prevent case warpage or deformation which can lead to malfunction. Kawasaki Heavy Industries, Ltd. Oil Pipe Joint Nut 8. Torque – Alternator Cover Bolts: If the lining thickness of either pad is less than the service limit [B], replace both pads in the caliper as a set.

If there does not appear to be enough sediment in a cell to short the plates, but that cell has a very low specific gravity after the battery is fully charged, the trouble may be that there is not enough acid in that one cell.

Engine Stop Switch 2. Main Fuse 30 A 5. Torque – Grip Hold Nut [S]: Cover Bushing Inside Diameter [A] Also, check to see that each cotter pin is in place and in good condition. If the corrugated fins are deformed, carefully straighten them with the blade of a thin kaawsaki driver.

  ACI 117-10 PDF

Moreover, if the owner’s manual supplied with a product is revised, this website may provide without notice the revised version, instead of the manual that had originally been issued at the time the product was released.

Kawasaki PRAIRIE 360 4×4 Service Manual

Torque Converter Cover Installation Follow the specified tightening sequence. Speedometer other than US Model 7. Do not loosen the locknuts [C] at the end of the tie-rod adjusting pfairie, or the toe-in of the front wheels will be changed.

Pad overworn or worn unevenly Tire worn Oil, grease on pads and disc Wheel rim warped Disc worn or warped Rear axle runout excessive Brake overheated Wheel bearing worn Rear Brake: If the axle is damaged or bent, replace it. To facilitate actual operations, notes, illustra- tions, photographs, cautions, and detailed descriptions have been included in each chapter wherever necessary. Torque – Crankshaft Sensor Mounting Bolts: Actuator Lever Assembly Installation Length Torque – Alternator Stator Bolts: The belt warning light will activate every key-on hours, or sooner if the belt becomes damaged or fails.